<%NUMBERING1%>.<%NUMBERING2%>.<%NUMBERING3%> PRTG Manual: Channel Definitions for xFlow, IPFIX, and Packet Sniffer Sensors

When adding Custom xFlow sensors, Custom IPFIX, or Custom Packet Sniffing sensors, you have the option to provide a Channel Definition using the following syntax (one entry per channel):

#<id>:<Name>
<Rule>

Syntax

  • The <id> must be 1 or a higher number, and it must be unique for the sensor. This means that each channel definition must have a unique ID.
    icon-i-roundThe maximum channel ID you can use is 2147483648 (2^31). Higher IDs are not supported. We recommend that you use channel IDs like 1, 2, or 3.
  • The <id> is linked to the historic data.
    icon-i-round-redAs soon as you change the ID, you lose the history for this particular channel that the ID was linked to.
  • One rule can span multiple lines.
  • The next rule starts with a # as the first character in a line.
  • The <name> is the channel's display name.
  • The rules are processed top to bottom (the number does not matter) and the data is accounted to the first match.
  • PRTG automatically adds one channel named Other. This channel counts all traffic for which you have not defined a specific channel.
  • After the name, you can use an optional [<unit>] to override the automatic unit, which is based on the source sensors.

The <Rule> syntax is identical to the one described in the Filter Rules for xFlow and Packet Sniffer Sensors section. Because data is accounted to the first match, make sure that you start with the most specific rule at the top and get less specific to the bottom.

icon-i-round-redWe recommend that you write the rules list in an external editor first and then paste it into the Channel Definition field of the sensor in PRTG. If the rules contain an error, the entries are removed after adding them.

icon-i-blueYou cannot delete channels of an existing sensor, even if you remove a channel from the channel definition. You also cannot change the display name of channels using the channel definition of custom flow sensors. Renaming is only possible via channel settings.

Example

General example:

#5:HTTP
Protocol[TCP] and 
(SourcePort[80] or DestinationPort[80] or SourcePort[8080] or 
DestinationPort[8080])

Channel definition example for differentiating by protocol:

#1:TCP
Protocol[TCP]
 
#2:UDP
Protocol[UDP]
 
#3:ICMP
Protocol[ICMP]

More

PRTG Manual:

Knowledge Base: How can I change the default groups and channels for xFlow and Packet Sniffer sensors?

Advanced Topics

Keywords: Flow,Flow Channel Definitions,Packet Sniffer,Packet Sniffer Channel Definitions